Installing the Driver Software. Modifying Configuration Parameters. Removing the Driver Software. Installing the Driver Software When the Windows Server system first boots up after installing a new hardware device, such as a Gigabit Ethernet Adapter, the system automatically detects the new hardware and prompts you to install the driver software for that device.
See Installing the Hardware for details. These drivers may need to be extracted to a temporary directory on your hard drive. To install the adapter software for Windows Server , do the following. When you boot up the Windows Server system after installing the network device, a series of Found New Hardware windows display. The Welcome to the Found New Hardware window then displays. The following window appears notifying you to wait while the wizard installs the software.
You must then perform a scan for hardware changes in the device manager, followed by re-installing the Broadcom device with the current adapter software as described in the " Installing the Driver Software " section.
Prior to uninstalling the Broadcom device, ensure to capture all Advanced Property settings because the parameters will be lost. To update the adapter software for Windows Server , do the following:. The Hardware Update Wizard searches for the appropriate driver and automatically updates the software.
Once installation of the driver software is complete, you are ready to modify configuration parameters. Back to Top. Although the default values should be appropriate in most cases, you may change any of the available options to meet the requirements of your specific system.
Once the adapter driver software has been installed, you can use this procedure to verify or change the following adapter properties: Click Start then select Control Panel from the pop-up menu. Double-click the System icon. Click the Hardware tab and then click Device Manager. The Device Manager window displays. Scroll down the list of hardware devices to Network Adapters.
Double-click the Gigabit Ethernet Adapter you want to configure. The Gigabit Ethernet Properties window displays, showing the General tab. The It is responsible for the QOS provisions on the local segment, and the avoidance of the "all packets are treated equally" issue, which falls onto the hub or switch servicing segment. Thus, when the local segment becomes congested and the hub or switch workload results in the delay dropping of packets, those packets with flags that correspond to higher priorities will receive perferential treatment, and will be serviced before packets with lower priorities.
Disabled by default, select Enable from the Value drop-down menu to enable this parameter. Once enabled, select Disable from the Advanced tab Value drop-down menu to disable this parameter. Normally the Checksum Offload function is computed by the protocol stack. By selecting one of the Checksum Offload parameters, the checksum can be computed by the Gigabit Ethernet Adapter. To enable one of the Checksum Offload parameters, select the parameter from the Advanced tab Value drop-down menu.
These parameters are described and shown below:. T he Ethernet WireSpeed parameter enables a BASE-T Ethernet adapter to establish a link at a lower speed when only 2 pairs of wires are available in the cable plant. By default, the adapter is set to Enable. PAUSE frames enable the adapter and the switch to control the transmit rate. We have scanned the file and URLs associated with this software program in more than 50 of the world's leading antivirus services; no possible threat has been detected.
Based on our scan system, we have determined that these flags are possibly false positives. It means a benign program is wrongfully flagged as malicious due to an overly broad detection signature or algorithm used in an antivirus program. Do you recommend it? Network Adapter Drivers for Windows Server HP t Flexible Thin Client drivers varies-with-device 4.
Leave a review. This is embarrassing
0コメント